Trunk setup procedure - review?
I need to change a single interface over to a two-interface Trunk group on a pair of 7200 chassis. Below is how I'm thinking it could be done, but I thought I'd post it here for the more experienced folks to look over and see if there's anything missing (or a better alternative). The switch config side of this is being handled by a fellow tech, and we've done this before on a 2200 (but as an initial config). So, anway...
Scenario: A pair of active/active 7200 chassis with four VCMP guests each. Guests run in four active/standby pairs. Usually, all VCMP guests on one chassis are active and the other standby (no technical reason for doing so, it's just easier to remember who's active).
Tagged interface 2.1 on each chassis is currently used for 19 vlans. Plan is to create a Trunk with interfaces 2.1 and 2.2 (not in use) in it on each.
Do this first on the "standby" 7200 chassis (all VMs in standby). Once complete, force failover all active VMs and then repeat on the other chassis. Force failover again (back to the original one) afterward to verify.
- Create "Trunk01" and add interface 2.2.
- Move a vlan over to it and verify nodes in that vlan recover on one or more VMs. Test a ping to a self IP, etc. Trunk01 will be used as a "tagged" interface.
- Once the secondary link connectivity looks good, move over the other vlans to Trunk01. Check to ensure nodes recover.
- Once all vlans have been moved from 2.1 to Trunk01, move 2.1 into the Trunk01 LAG with 2.2.
- Force failover the active VMs to the standby ones and repeat the procedure on the other chassis. Once complete, force failover back to verify.
Thanks!