Oreoluwa
Altocumulus
AltocumulusRDP TO INTERNAL SERVERS THROUGH F5 BIG IP LTM
Hi Guys,
How do i configure the F5 BIGIP appliance to allow RDP to internal servers?
Please this is urgent.
Forum Discussion
7 Replies
Simon_BlakelyEmployee
It really depends on what you are wanting to do ...
If you have APM, you can set up a full Virtual Desktop Infrastructure gateway
AskF5 | Manual Chapter: Using APM as a Gateway for RDP Clients
Otherwise, you can just have a load-balancing passthough with a FastL4 virtual.
OreoluwaHi, thanks for answering. When you say load balancing passthrogh with a FastL4 virtual, are you saying to use the default normal virtual server setting for RDP too?
- Simon_Blakely
> When you say load balancing passthrogh with a FastL4 virtual, are you saying to use the default normal virtual server setting for RDP too?
Yes. You may need Source Address persistence or something to keep connections to the same server.
- Oreoluwa
What do I use as the Service port on the Virtual Server?
- Simon_Blakely
https://en.wikipedia.org/wiki/Remote_Desktop_Protocol
> By default, the server listens on TCP port 3389[1] and UDP port 3389
- Oreoluwa
Okay. Then I believe when i create the Virtual server, for the service port i would be using Other: 3389 and the protocol to use will be TCP?
- Simon_Blakely
Since RDP uses both UDP and TCP, you need protocol any, or two separate virtual servers for UDP port 3389 and TCP port 3389.