Forum Discussion

AlvinNG_GTI's avatar
AlvinNG_GTI
Icon for Altostratus rankAltostratus
Feb 13, 2023

How to configure the AOM for rSeries hardware appliance

Hello,

As I encountered something when I want to shutdown the rSeries hardware appliance with F5OS 1.3.1 by CLI "halt". The process as smooth and shown "The system was halted". But I tried to Power on the appliance via front panel touch screen NO any respond.

Therefore, I would like to configure the AOM for remote control the rSeries Power On/Off the appliance.

But I just can apply the AOM networking settings, no any command for configure the AOM user such as CLI "aom_setup_user".

 

May you experienced this behavior or there have solution?

If so, don't mind share to us. Thank you very much.

 

 

Thanks and Best Regards,

Alvin Ng

    • AlvinNG_GTI's avatar
      AlvinNG_GTI
      Icon for Altostratus rankAltostratus

      Hi TMD,

      Thanks for your sharing.

      Let me try it in my rSeries appliance. If it is fine, I will use this method rather than configure AOM.

      SInce my concern as no any respond to power on the appliance from touch screen before, and require to unplug and re-plug the power pord action. That make me create the post to discuss how configure the AOM on rSeries.

       

      Thanks and Best Regards,

      Alvin Ng

  • With the F5OS the AOM is also called now LOP (Lights Out Processor)  , so search for info about it.

    • jdshewey's avatar
      jdshewey
      Icon for Nimbostratus rankNimbostratus

      Pretty sure you have that backward - LOP is now called AOM - starting circa version 11 and the iSeries units (after the buffalo jumps). Mine (an rSeries unit) has "AOM" on the front LCD panel for the info/config.