Forum Discussion
Ilian_Ivanov
Jun 05, 2017Nimbostratus
Hi,
You can check what is your source IP address when trying to connect to the server.
"ip route get SERVER_IP" in bash mode. Just be sure that you are in the correct partition.
For example:
(bigIP)(cfg-sync In Sync)(Active)(/Common)(tmos) bash
[bigIP:Active:In Sync] ~ rdexec 2 bash
[bigIP:Active:In Sync:%2] ~ [bigIP:Active:In Sync:%2] ~ ip route get 1.1.1.1 1.1.1.1 via 10.10.10.1 dev eth0 src 10.10.10.71 cache mtu 1500 advmss 1460 hoplimit 64
Then I can suggest you to check if that IP/Port are allowed on your FW. Have in mind that 10.10.10.71 is your self-IP, you will need to allow also the floating IP address (if you have one).