solmon
Nimbostratus
Jun 07, 2021F5 APM HA build
hi All
wondering if some one can chek my steps and correct me if i m wrong,
currnetly we have single F5 running LTM and APM as standalone active device , plan is to make it a HA cluster , i.e. add standby node.
my steps are
step 0 : backup and export archive.
1) build new standby node to same spec as active ,
2) add new non-floating to current device , and convert the current non-float to floating so no routing changes needed.
3) test at this point
4) configure HA using run config sync HA/utility and sync config,
then finally failover and failback test , anything else i need to check >? current f5 is v12.1.2
thanks
S